Home > Products > Petrol Air Compressors > 35 cfm Petrol Air Compressor
Petrol engine drive — light enough to move by hand, no power supply required. The 35 cfm Petrol Air Compressor is built for continuous industrial duty. It runs on a direct-coupled air end with no belts to re-tension, and it is delivered as a complete package — airend, motor, cooler, separator and controller on one base frame — so on-site work is limited to power, piping and a drain.
A single cutaway view of the whole unit: airend, drive motor, separator tank, coolers, filtration and controller mounted on one base frame. Use it to check the space envelope and service access before ordering.
Air-cooled petrol engine driving the compression element directly, for sites with no power supply.
Close-up of the running gear and fasteners so you can see the actual build standard rather than a render.
Close-up of the running gear and fasteners so you can see the actual build standard rather than a render.
Close-up of the running gear and fasteners so you can see the actual build standard rather than a render.
Close-up of the running gear and fasteners so you can see the actual build standard rather than a render.
Close-up of this part of the machine.
| Model No. | Free Air Delivery (cfm) | Make | Engine Power | Full Load Speed | Off load Speed | Fuel Tank Capacity | Weight | Outlets | Dimension (mm) | ||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 100 | 116 | 145 | 174 | ||||||||||
| psi | psi | psi | psi | hp | rpm | rpm | L | kg | L | W | H | ||
| WGD35 | 35 | 28 | HONDA | 10 | 3600 | 5.5 | 270 | 2×1/2" | 682 | 640 | 1184 | ||
| WGD125 | 125 | 105 | 85 | QUANCHAI | 30 | 2900 | 2100 | 60 | 650 | 2×3/4" | 2930 | 1540 | 1280 |
Breaking and compaction work in built-up areas.
Where there is no power and no room for a diesel unit.
Light breaking, drilling and spraying.
Portable air for recovery and repair crews.
Every unit ships with an 18-month warranty on the air end and 12 months on the rest of the machine, counted from commissioning or 24 months from shipment, whichever comes first.
Each machine is run on the test bench and the delivered flow, working pressure, current draw and noise level are recorded against the datasheet before it is crated.
Installation drawings, piping diagrams and a commissioning checklist are supplied with the machine, with remote engineering support during start-up.
Airends, motors, controllers, filters, separators and cooler assemblies are held in our own warehouse, so service parts are not tied to a production run.
Road breaking, demolition, sandblasting and similar work where the machine has to be moved by hand or carried on a small vehicle and there is no power on site.
The machine is supplied as an air source. Breaking hammers and other air tools are available separately — see the Tools and Accessories section.
Recoil or electric start depending on the model; both are listed in the specification table.
Follow the engine manufacturer schedule for the engine, and the compressor oil schedule in the manual. Dusty sites mean shorter intervals.
Tell us your requirements and our sales team will reply within 24 hours.
