Home > Products > Tools and Accessories > Pneumatic Jack Hammer
Heavy-duty pneumatic breaking hammer for quarry, road and demolition work. The Pneumatic Jack Hammer is built for continuous industrial duty. It runs on a direct-coupled air end with no belts to re-tension, and it is delivered as a complete package — airend, motor, cooler, separator and controller on one base frame — so on-site work is limited to power, piping and a drain.
| Model | Piston Diametermm | Piston strokemm | Weight kg | Total lengthmm | Blow frequency bpm | Shank size mm | Air consumptionm³/min | Air inlet PT | Air hosemm(in) |
|---|---|---|---|---|---|---|---|---|---|
| TPB-40 | 44 | 146 | 18 | 660 | 1,100 | 25.4Hx108 L | 1.6 | 3/4 | 19(3/4) |
| TPB-40SV | 44 | 146 | 19.5 | 653.5 | 1,100 | 25.4Hx108 L | 1.6 | 3/4 | 19(3/4) |
| TPB-73 | 57.15 | 144 | 31 | 690 | 1,200 | 31.7Hx154 L | 1.8 | 3/4 | 19(3/4) |
| TPB-90 | 66.67 | 152 | 42 | 723 | 1,250 | 31.7Hx154 L | 2.2 | 3/4 | 19(3/4) |
Primary and secondary breaking with no power on site.
Surface removal and repair.
Controlled demolition work.
Trenching, breaking and repair.
Reducing oversized material at the face.
Every unit ships with an 18-month warranty on the air end and 12 months on the rest of the machine, counted from commissioning or 24 months from shipment, whichever comes first.
Each machine is run on the test bench and the delivered flow, working pressure, current draw and noise level are recorded against the datasheet before it is crated.
Installation drawings, piping diagrams and a commissioning checklist are supplied with the machine, with remote engineering support during start-up.
Airends, motors, controllers, filters, separators and cooler assemblies are held in our own warehouse, so service parts are not tied to a production run.
The air consumption of each model is in the specification table. Add up the tools you intend to run together and size the compressor with a margin on top.
The air inlet size is in the table. Use a hose bore that matches it — undersized hose costs you more impact energy than the tool model does.
Daily lubrication through the in-line oiler and regular checking of the retaining latch and the shank for wear. Replace the chisel when the shank is worn.
The tool is supplied as standard; chisels and points are ordered separately to suit the job.
Tell us your requirements and our sales team will reply within 24 hours.
