Home > Products > Low Pressure Air Compressors > 22-355 kW 2-Stage Compression Low Pressure
Low-pressure air end running at 3-5 bar — volume without wasted compression. The 22-355 kW 2-Stage Compression Low Pressure is built for continuous industrial duty. It runs on a direct-coupled air end with no belts to re-tension, and it is delivered as a complete package — airend, motor, cooler, separator and controller on one base frame — so on-site work is limited to power, piping and a drain.
Close-up of this part of the machine.
Close-up of this part of the machine.
Specifications for this model are available on request.
High-volume, low-pressure air is the core requirement.
Process air where volume matters more than pressure.
Furnace and forming line air.
Dilute-phase transport of powders and granules.
Cement, fly ash and similar materials.
Every unit ships with an 18-month warranty on the air end and 12 months on the rest of the machine, counted from commissioning or 24 months from shipment, whichever comes first.
Each machine is run on the test bench and the delivered flow, working pressure, current draw and noise level are recorded against the datasheet before it is crated.
Installation drawings, piping diagrams and a commissioning checklist are supplied with the machine, with remote engineering support during start-up.
Airends, motors, controllers, filters, separators and cooler assemblies are held in our own warehouse, so service parts are not tied to a production run.
Processes that need volume rather than pressure: textile and air-jet weaving, chemical fibre spinning, glass making, and dilute-phase conveying of cement or fly ash.
Because you would be paying to compress air to a pressure you then throw away at a regulator. A low-pressure airend delivers the same volume with a lower compression ratio, so the specific power is lower.
Yes. The inverter option is listed in the specification table and suits the varying demand typical of these processes.
The lower compression ratio means a lower discharge temperature, which is easier on the oil and the separator element.
Tell us your requirements and our sales team will reply within 24 hours.
